3 Differences Between Glass Tubes & RF Metal Tubes For Laser Marking Machine
You are here: Home » CASE » Laser Marking Cases » 3 Differences Between Glass Tubes & RF Metal Tubes For Laser Marking Machine

3 Differences Between Glass Tubes & RF Metal Tubes For Laser Marking Machine

Views: 3005     Author: Site Editor     Publish Time: 2022-05-21      Origin: Site


3 Differences Between Glass Tubes & RF Metal Tubes For Laser Marking Machine

图片1


Service life

1. The lifespan of the CO2 RF tube laser marking machine can reach more than 60,000 hours, and it can generally be used for 7 years.

2. The glass tube laser marking machine can only work for about 2500 hours. Generally, a glass tube is replaced half a year. It cannot be reused and should be replaced in time.


Use effect

The CO2 RF tube laser marking machine has a fine spot of 0.07mm, which is more than 3 times finer than that of glass tubes. It has high precision and small heat diffusion area, and can mark and cut very fine products.


Performance

1. The RF tube of the carbon dioxide laser marking machine is a fully sealed metal tube, which uses a low-voltage power supply of 30 volts, which directly avoids some disadvantages caused by using a high-voltage power supply.

2. The glass tube uses a high-voltage power supply of 10,000 volts or even higher, which is dangerous in addition to being unstable. Working for a long time makes the power supply easy to age, and has great interference to the control system. Improper operation can easily burn the motherboard, and it is more likely to be affected by voltage and damage its normal functions.


If you are looking for aCO2 Laser marking machine,Welcome to Contact us.

Message now
  • Factory Address:100 Meters South of 
    Fengqi,Shizhong District,Jinan,China
  • call us on:
    +86-15064149218